next up previous index
Next: Output locations Up: Description of commands Previous: Numerics   Index

Output

There are two categories of output commands:
  1. Locations
    commands defining sets of output locations at which the user requires output. Each set is indicated with a name ('sname' in this manual) which must be unique and not more than 8 characters long.


    Types of sets of output points:

    FRAME to define a set of output locations on a regular grid  
    GROUP to define a set of output locations on a regular or curvilinear grid  
    CURVE to define a set of output locations along a curve  
    RAY to define a set of output locations along a depth or bottom contour line  
      (with ISOLINE)  
    ISOLINE to define a set of output locations along a depth or bottom contour line  
      (with RAY)  
    POINTS to define a set of isolated output locations  

    Commands RAY and ISOLINE cannot be used in 1D-MODE. If one gives one name for two sets of output locations, the first set is lost (first in the sequence in the command file). Two special names BOTTGRID and COMPGRID are reserved for use by SWASH (see below). The user may not define sets with these names.

  2. Write / plot
    commands defining data file output (write) at the above defined set(s) of output locations:

    BLOCK write spatial distributions (only for FRAMEs and GROUPs)  
    TABLE write output for (set of) output location(s)  

    Command BLOCK cannot be used in 1D-MODE.



Subsections
next up previous index
Next: Output locations Up: Description of commands Previous: Numerics   Index
The SWASH team 2017-04-06